The popular Reyburn CyberTuner, TuneLab, and Veritune piano tuning softwares are available for "pocket PC" handheld computers as well as the iPhone 4 and iPod Touch. You can learn all about these softwares at: www.reyburn.com, www.tunelab-world.com, and www.veritune.com
Once you get your software, you'll need one of our stands to support your pocket PC on the piano while tuning. This stand holds the PC securely, slips easily on or off, and works equally well on verticals or grands. Fits any brand of pocket PC except phone/PC combinations For grands, just slip the tuning tip over a tuning pin, as shown at top right. You can then face it any direction, easily adjust the tilt for best viewing angle, and rotate the PC to horizontal when running in full screen mode. Or, swing the tuning tip back and the stand will sit like a tripod on the plate or strings. Another option is our Plate Mount accessory, which clamps to most plate struts. The same options work equally well on vertical pianos. Swing the tuning tip back as shown at right and the stand will sit on the lid, pin block, or other horizontal surface. Most convenient and secure is to mount the stand on vertical piano tuning pins, where it can be faced right or left, and tilted up or down. For more photos of the PC Stand in various situations, click here. Made of high density polyethylene, the stand weights just under 4 oz. (112 gm). Requires a standard thread tuning tip (not included. Most techs have an extra, or we can provide one for an additional $8.00). PC Stand Price: $ 68.00 (specify Velcro or Clips type, see below) Star tuning tip for PC Stand: $8.00	Above: Reyburn CyberTuner display Below: TuneLab display
	Five stand models available: We supply the PC Stand with your choice of two PC holding systems: the "Clips" type shown at left and in the pictures above, and the Velcro type shown below left. The Clips type is available in four sizes: Small: for HP 1700/1900/4000 series, HP 110, 111, 114, HP rx3115, rx3417, rx1715, rx1950, series Medium: for HP 2200 series Large: for Compaq 3600 thru 3900 series, HP h4350, h5150, h5550, HP hx2100, hx2400, hx2700, hx4700, hx5915, HP 211, 214, all Dell Axim, and Toshiba e755 iPhone 4/iPod Touch: Fits devices that measure 57-59mm wide and 7-10mm thick The clips stands hold the bare pocket PC, which simply slips into the plastic clips. If you have a PC with an optional high capacity battery which bulges out in back making the unit thicker than standard, you will need the Velcro type stand. The Velcro mount includes a corresponding piece of self-adhesive Velcro that you attach to your PC or sleeve. You can then stick the PC to the stand easily and securely for tuning, or pull it loose for other uses. Converting your existing stand to a different model: If you switch to a different size Pocket PC there is no need to buy a complete new stand. Any stand can be converted to a different size or type. Just order the appropriate size "Clips" conversion kit or the "Velcro" conversion kit (see order form).
Plate Mount for grands Often you'd like to have the PC just a bit higher and farther away than on a grand tuning pin. This accessory is the answer. Just pop it onto a plate strut, and slip the tuning tip of your PC Stand into the hole. The PC can then be rotated any direction with just a touch. Rubber buttons and a non-marring screw tip hold it securely to most struts. The Plate Mount is especially convenient when tuning the bass and tenor. Plate Mount Price: $ 28.00	Below: Verituner Pocket display