Piano Placement Options for the PC Stand
The images below show how the PC Stand can hold your Pocket PC securely and conveniently on any piano. Note that some images show the "clips" mount, and others the Velcro mount with  the PC in its expansion sleeve.

On Grands:
PC Stand on tuning pin
PC Stand sitting on plate
PC Stand in Plate Mount
Slip the tuning tip over any pin
Rotate the tuning tip back and set the stand on the plate (the included vinyl tip cap prevents scratching)
Use the Plate Mount accessory on any strut (the vinyl cap is removed so the tip fits directly into the Plate Mount
On Verticals:
PC Stand on vertical T-pin running Pocket RCT
Slip the tuning tip onto any pin; tilt the PC up or down for best viewing angle
PC Stand on vertical T-pin running Verituner Pocket
Most convenient is to orient the body of the stand sideways on the pin, between 8:00 and 10:00 or 2:00 and 4:00, then rotate the PC back to vertical. You can then swing the stand in or out so the PC faces slightly to one side. This allows optimal viewing from any part of the keyboard.
PC Stand atop vertical pinblock, running TuneLab software
Rotate the tuning tip back and set the stand on the pin block
Copyright © 2002 Spurlock Specialty Tools